UV printers,like computers,are mainly composed of software and hardware.In the UV printer industry,one is the external structure and the other is the internal structure.This article introduces the main structure of the UV flatbed printer.
One.Introduction to the main structure of UV flatbed printer
1.External structure:UV flatbed printer includes external printer head,guide rail,grating,belt,ink system,control panel,etc.
2.Internal structure:Contains circuit boards,control boards,software boards,power cords,motors and various electronic components.
Two.Description of the core components of UV flatbed printer
1.UV printer nozzle
The uv printer nozzle is a very important place in daily use.It not only needs regular cleaning,but also during use,it is required that the surrounding ambient temperature should not exceed 35 degrees,if it is too low,it should not be less than 5 degrees,and the humidity should not exceed 60.%,to avoid causing water on the surface of the substrate and poor adhesion of printed patterns.
2.UV printer board
The board card is the"brain"of the entire uv flatbed printer.In daily use,do not drip in water,liquid,etc.,and install the corresponding ground wire to avoid short circuit and burnout.When purchasing equipment,you must see if you add a dongle.If you do,you must remove it from the manufacturer to avoid the need to pay for each subsequent upgrade.
3.Servo motor
The servo motor is the key to ensure the printing length,accuracy and stability of the equipment.When purchasing equipment,open the cover of the uv flatbed printer and check the brand on the motor.Generally,imported Japanese and German motors are of high quality,while domestic ones are of poorer quality.
Three.Summary of UV printer manufacturer Dacen
This article is the content of"Introduction to Main Structure of UV Flatbed Printer",I hope to help you.
